Wbr 1310 not updating firmware 100 dating sites in country

This "work" has been done in my free time and therefore it's not related to my current company in any way.So I have a D-Link WBR 1310 router laying around, and I was wondering if there is a way to get dd-wrt or another alternate OS onto it. So, there are two ways to get the password of your management interface.

wbr 1310 not updating firmware-16

Wbr 1310 not updating firmware

The following output shows the results of a Nmap scan of three different D-Link DIR devices (DIR-300rev A, DIR-300rev B, DIR-600rev B): [email protected]:~# nmap -s SV -p 23 192.168.178.133,144,222Starting Nmap 6.01 ( at 2013-04-30 CESTNmap scan report for 192.168.178.133Host is up (0.0067s latency).

PORT STATE SERVICE VERSION23/tcp open telnet D-Link 524, DIR-300, or WBR-1310 WAP telnetd MAC Address: 1C: BD: B9: A7:7F:74 (D-link International PTE Limited)Service Info: Device: WAPNmap scan report for 192.168.178.144Host is up (0.0068s latency).

Apple Airport Current Status: Compatible Recommendation: Suitable for 1-3 phones Comments: There are no known issues with this router although it is best used for smaller offices (1-3 phones).

This device is not believed to offer Qo S which may be a drawback in certain deployments.

PORT STATE SERVICE VERSION23/tcp open telnet D-Link 524, DIR-300, or WBR-1310 WAP telnetd MAC Address: :5A:38:7D:77 (D-Link)Service Info: Device: WAPNmap scan report for 192.168.178.222Host is up (0.0031s latency).

PORT STATE SERVICE VERSION23/tcp open telnet D-Link 524, DIR-300, or WBR-1310 WAP telnetd MAC Address: : DB:6D: FE (D-Link)Service Info: Device: WAP The credentials are well known and documented on lots of different places around the internet. If you are interested on the configuration of this backdoor take a look at the following configuration of a DIR-300 device: /dev/console if [ -f "/usr/sbin/login" ]; then lf=`rgdb -i -g /runtime/layout/lanif` telnetd -l "/usr/sbin/login" -u Alphanetworks:$image_sign -i $lf & else telnetd & [email protected]:~/firmware/DIR300-extracted# cat rootfs/etc/config/image_signwrgg19_c_dlwbr_dir300 This is quite amazing but it would be a lot better if you could configure the box via the web management.

This router has known issues with Vo IP services if SIP ALG is not disabled.

Disable the SIP ALG setting on the router available in firmware releases 2.2.4 and higher.

The router's NAT service for SIP should be disabled, with the command: no ip nat service sip udp port 5060 For Firewall versions SIP ALG needs disabling: no fixup sip D-Link Models: DIR-615, EBR-2310 Current Status: Compatible after Changes, Hardware Revision B Only Recommendation: Disable SIP ALG Comments: This applies to Hardware Revision B only.

Other hardware revisions are not compatible with Vo IP as they do not have the disable SIP ALG option.

It is too bad if your device has a backdoor directly from the vendor.

Tags: , ,